Qos Rsvp Detail - 3Com SuperStack II 9300 Command Reference Manual

qos rsvp detail

3500
9000
9400
3900
9300
For CoreBuilder 9000: Applies to Layer 3 switching modules only.
Displays detailed RSVP information when RSVP is enabled.
Valid Minimum Abbreviation
q r de
Important Consideration
If no flows are installed on the system or on a Layer 3 module, the
command displays only the summary information.
Options
Prompt Description
Level of RSVP If RSVP flows are available to report,
information the amount of RSVP information
(when flows you want
are installed)
Fields in the QoS RSVP Detail Display
Field Description
Excess loss eligible Whether excess packets are loss-eligible.
Excess service Service level for excess/policed traffic (best or low).
Per resv bandwidth Largest reservation that RSVP attempts to install.
Policing option When to drop excess packets. Edge policing causes excess
packets to be dropped only at the edge (that is, when the
traffic has not yet passed through any network device that has
already performed policing for that flow).
Session Session numbers, destination IP addresses and ports, protocols,
number of senders, receivers, and RSVP reservations.
Session – receiver Port numbers, an RSVP style (ST) of fixed filter (FF), shared
and session explicit (SE), or wildcard filter (WF), next hop addresses, LIH
reservation values, TTD values, bandwidth values, burst values, and filters.
Session – sender Port numbers, source IP addresses, previous hop addresses,
Logical Interface Handle (LIH) values, Time To Die (TTD) values,
bandwidth values, burst size values, and output ports.
Session – Actual flow that was installed on the system (shown in the last
installed flows portion of the output).
Total resv Admission control policy. RSVP begins to refuse reservations
bandwidth when the requested bandwidth on an output link exceeds the
total reservable bandwidth.
qos rsvp detail 729
Possible Values [Default]
all –
session
IP