Bridge Cos Modify - 3Com SuperStack II 9300 Command Reference Manual

bridge cos modify

3500
9000
9400
3900
9300
For CoreBuilder 9000: Applies to Layer 2 switching modules only.
Changes how the eight priority values (0 – 7) are assigned to each of the
two hardware queues and changes the optional rate limit on queue 1
(the high priority queue).
Valid Minimum Abbreviation
b c m
Important Considerations
Because you cannot configure a rate limit for queue 2, the
Administration Console prompts you to enter a rate limit only if you
select queue 1.
When you assign priority values to a given queue, the system
automatically assigns the remaining priority values to the other queue.
If CoS is disabled, you can still modify the queue settings; however,
they do not affect traffic until CoS is enabled.
Options
Prompt Description
Queue Number of the device
index queue whose settings you
want to modify
Rate limit Throughput limit that
applies only to queue 1
and is expressed as a
percentage
Class of IEEE 802.1p priority values
service tags that you want to assign to
the selected queue. Use
commas to separate
multiple values.
bridge cos modify
Possible Values [Default]
1 –
2
? (for a list of
selectable
indexes)
Whole numbers 100 (factory default),
from 1 – 100 or current value
0 – 7 For queue 1, values
4, 5, 6, 7 (factory
all
default), or current
? (for a list of values
possible values)
For queue 2, values
0, 1, 2, 3 (factory
default), or current
values
269