Adding Fuel - Toro 07383 Operator's Manual

1
Figure 13
1. Filler cap
2. Dipstick
3. If the oil level is low, remove the filler cap (Figure 13)
and add enough oil to raise the level to the Full mark
on the dipstick.
Note: When adding oil, remove dipstick to allow
proper venting. Pour oil slowly and check the level
often during this process. Do not overfill.
Important: When adding engine oil or filling
oil, there must be clearance between the oil fill
device and the oil fill hole in the valve cover as
shown in Figure 14. This clearance is necessary
to permit venting when filling, which prevents oil
from overrunning into the breather.
G021228
2
1. Note clearance
4. Install the dipstick firmly in place.

Adding Fuel

Toro strongly recommends the use of fresh, clean,
unleaded regular grade gasoline in Toro gasoline
powered products. Unleaded gasoline burns cleaner,
extends engine life, and promotes good starting by
reducing the build–up of combustion chamber deposits.
Use a minimum octane rating of 87.
Fuel tank capacity: 25 l (6.5 US gallons).
Note: Never use methanol, leaded gasoline, gasoline
containing methanol, gasoline containing more than
10% ethanol, gasoline additives, or white gas because
engine fuel system damage could result.
18
Figure 14