Table of Contents
Advertisement
2
Installing the ROPS (TC
Models Only)
Parts needed for this procedure:
1
ROPS frame
6
Bolt, 1/2 inch
Procedure
1. Align each side of the ROPS with the mounting holes
on each side of vehicle frame as shown in Figure 4.
2. Secure each side of the ROPS to frame with 3 bolts
(1/2 inch) and tighten then to 115 N-m (85 ft-lb).
1. ROPS
3
Checking the Fluid Levels
No Parts Required
Procedure
1. Check the engine oil level before and after the engine
is first started, refer to Checking the Engine Oil Level
(page 17).
2. Check the transaxle/hydraulic fluid level before
the engine is first started, refer to Checking the
Transaxle/Hydraulic Fluid Level (page 20).
Figure 4
2. Mounting bracket
3. Check the brake fluid level before the engine is first
started, refer to Checking the Brake Fluid (page 22).
Product Overview
Controls
Note: Determine the left and right sides of the machine
from the normal operating position.
Accelerator Pedal
The accelerator pedal (Figure 5) gives the operator the ability
to vary the engine and ground speed of the vehicle when
the transmission is in gear. Pressing the pedal increases the
engine rpm and ground speed. Releasing the pedal decreases
the engine rpm and ground speed of the machine.
1. Clutch pedal
2. Brake pedal
Clutch Pedal
The clutch pedal (Figure 5) must be fully pressed to disengage
clutch when starting the engine or shifting transmission gears.
Release the pedal smoothly when the transmission is in gear
to prevent unnecessary wear on the transmission and other
related parts.
Important: Do not ride the clutch pedal during
operation. The clutch pedal must be fully out or the
clutch will slip causing heat and wear. Never hold the
vehicle stopped on a hill using the clutch pedal. Damage
to the clutch may occur.
13
Figure 5
3. Accelerator pedal
Advertisement
Table of Contents
