Lubrication; Greasing Bearings And Bushings - Toro 07383 Operator's Manual

Lubrication

Greasing Bearings and
Bushings
Service Interval: Every 100 hours (lubricate more frequently
in heavy duty applications).
The vehicle has grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium Base Grease.
The grease fitting locations and quantities are as follows:
•
Ball joints (4), tie rods (2) pivot mounts (2) and steering
cylinder (2) (Figure 36)
•
Spring tower (2) (Figure 37)
•
Clutch (1) and brake (1) (Figure 38)
•
U-joint (18), and 4 wheel drive shaft (3) (Figure 39)
Important: When greasing the drive shaft universal
shaft bearing crosses, pump grease until it comes out
of all 4 cups at each cross.
1. Wipe each grease fitting clean so foreign matter cannot
be forced into the bearing or bushing.
2. Pump grease into each bearing or bushing.
3. Wipe off excess grease.
Figure 36
35
Figure 37
G021290
Figure 38