Connecting Zone 2 - Onkyo TX-NR5007 Instruction Manual

Multi Zone—Continued
In addition to your main listening room, you can also enjoy playback in the other room, or as we call Multi Zone. And,
you can select a different source for each room.

Connecting Zone 2

There are two ways you can connect Zone 2 speakers:
1. Connect them directly to the AV receiver.
2. Connect them to an amp in Zone 2.
Connecting Your Zone 2 Speakers Directly
to the AV receiver
This setup allows 7.2-channel playback in your main
room and 2-channel stereo playback in Zone 2, with a
different source in each room. This is called Powered
Zone 2, as the Zone 2 speakers are powered by the AV
receiver. Note that when Powered Zone 2 is turned off,
you can enjoy 9.2-channel playback in your main room.
To use this setup, you must set the "Powered Zone2"
setting to "Act" (see page 134).
Hookup
• Connect your Zone 2 speakers to the AV receiver's
FRONT WIDE/ZONE 2 L/R speaker terminals.
Main room
TV
AV receiver
Zone 2
R
Notes:
• With this setup, the Zone 2 volume is controlled by the
AV receiver.
• Powered Zone2 cannot be used if "Speakers
Type(FrontB)" is set to "Normal", "Bi-Amp" or
"BTL" (see page 57).
Connecting Your Zone 2 Speakers to an
Amp in Zone 2
This setup allows 9.2-channel playback in your main lis-
tening room and 2-channel stereo playback in Zone 2,
with a different source in each room.
Hookup
• Use an RCA audio cable to connect the AV receiver's
ZONE 2 PRE OUT L/R jacks to an analog audio input
on your Zone 2 amp.
• Connect your Zone 2 speakers to the speaker terminals
on your Zone 2 amp.
Main room
Zone 2
R
Note:
With the default settings, the Zone 2 volume must be set
on the Zone 2 amp. If your Zone 2 amp has no volume
control, set the "Zone2 Out" setting to "Variable" so that
you can set the Zone 2 volume on the AV receiver (see
L
page 135).
TV
AV receiver
IN
R L
Receiver/
integrated amp
L
131