Onkyo TX-NR5007 Instruction Manual page 96

Advanced Setup—Continued
Surr Back Ch
LPF of LFE (Low-Pass Filter for the LFE Channel)
This setting is not set automatically by Audyssey MultEQ
page 61).
With this setting, you can specify the cutoff frequency of the LFE channel's low-pass filter (LPF), which can
be used to filter out unwanted hum. The LPF only applies to sources that use the LFE channel.
* If you're using THX-certified speakers, select "80Hz(THX)".
*9
DoubleBass
This setting is not set automatically by Audyssey MultEQ
page 61).
With the Double Bass function, you can boost bass output by feeding bass sounds from the front left and right,
center channels to the subwoofer.
* If you're using THX-certified speakers, select "Off(THX)".
Notes:
*1 If the "Subwoofer" setting is set to "No", the "Front" setting is fixed at "Full Band".
*2 If the "Front" setting is set to anything other than "Full Band", "Full Band" cannot be selected here.
*3 If the "Surround" setting is set to "None", this setting cannot be selected.
*4 If the "Surround" setting is set to anything other than "Full Band", "Full Band" cannot be selected here.
*5 If the "Powered Zone2" setting is set to "Act" (page 134), this setting cannot be selected.
*6 If the "Powered Zone3" setting is set to "Act" (page 134), or "Speakers Type(FrontA)" setting is set to "Bi-Amp" or "BTL"
(page 58), this setting cannot be selected.
*7 If the "Speakers Type(FrontB)" setting is set to "Normal", "Bi-Amp" or "BTL" (page 57), this setting cannot be selected.
*8 If the "Surr Back" setting is set to "None", this setting cannot be selected.
*9 This function can be set only if the "Subwoofer" setting is set to "1ch" or "2ch", and the "Front" setting is set to "Full Band".
*10 If the Powered Zone 2 is being used (page 134), this setting cannot be selected.
Subwoofer, Front, Center, Surround, Surr Back
(Setting Speakers A and Speakers B)
If you're using Speakers B, you can choose whether or not to use the subwoofer, center, surround, and surround
back speakers with the Speakers A and Speakers B configurations independently. You cannot choose whether
or not to use the front speakers.
Notes:
• These settings can only be displayed when the "Speakers Type(FrontB)" setting is set to other than "Not Use"
(page 57).
• You cannot select speakers that you set to "No" or "None".
96
*8 1ch: Select if only one surround back L speaker is connected.
2ch: Select if two (left and right) surround back speakers are connected (default).
80Hz(THX) (default), 90Hz, 100Hz, 120Hz
On: Double Bass function on (default).
Off (THX): Double Bass function off.
Not Use: Select if you don't want to use each speaker with Speakers A or Speakers B.
Use: Select if you do want to use each speaker with Speakers A or Speakers B.
®
XT Room Correction and Speaker Setup (see
®
XT Room Correction and Speaker Setup (see