Setting The Display Brightness; Muting The Av Receiver; Using The Sleep Timer - Onkyo TX-NR5007 Instruction Manual

Basic Operations—Continued

Setting the Display Brightness

You can adjust the brightness of the AV receiver's dis-
play.
Press the [RECEIVER] button,
Remote
controller
and then press the [DIMMER]
button repeatedly to select:
• Normal + VOLUME light on.
• Normal + VOLUME light off.
• Dim + VOLUME light off.
• Dimmer + VOLUME light off.
Alternatively, you can use the AV
receiver's [DIMMER] button (North
American models).

Muting the AV Receiver

You can temporarily mute the output of the AV receiver.
Remote Press the [RECEIVER] button,
controller
and then press the [MUTING] but-
ton.
The output is muted and the MUTING
indicator flashes on the display, as
shown.
To unmute the AV receiver, press the
[MUTING] button again, or adjust the
volume.
The Mute function is cancelled when
the AV receiver is set to Standby.
Tip:
You can specify how much the output is muted with the
"Muting Level" setting (page 110).

Using the Sleep Timer

With the sleep timer, you can set the AV receiver to turn
off automatically after a specified period.
Remote Press the [RECEIVER] button,
controller
and then press the [SLEEP] but-
ton repeatedly to select the
required sleep time.
The sleep time can be set from 90 to 10
minutes in 10 minute steps.
The SLEEP indicator appears on the
display when the sleep timer has been
set. The specified sleep time appears on
the display for about five seconds, then
the previous display reappears.
If you need to cancel the sleep timer, press the [SLEEP]
button repeatedly until the SLEEP indicator disappears.
To check the time remaining until the AV receiver sleeps,
press the [SLEEP] button. Note that if you press the
[SLEEP] button while the sleep time is being displayed,
you'll shorten the sleep time by 10 minutes.
69