Changing The Input Display - Onkyo TX-NR5007 Instruction Manual

First Time Setup—Continued
3 Use the Up and Down [q]/[w] but-
tons to select "3. Tuner", and
then press [ENTER].
The "Tuner" menu appears.
(North American models)
(European and Asian models)
4
Use the Left and Right [e]/[r]
buttons to select:
(North American models)
200kHz/10kHz:
50kHz/9kHz:
(European and Asian models)
10kHz: Select if 10 kHz steps are
9kHz: Select if 9 kHz steps are used
5
Press the [SETUP] button.
The setup menu closes.
Note:
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.

Changing the Input Display

If you connect an u-capable Onkyo MiniDisc
recorder, CD recorder, or RI Dock to the TV/TAPE IN/
OUT jacks, or connect an RI Dock to the GAME IN or
VCR/DVR IN jacks, for u to work properly, you must
change this setting.
This setting can only be changed on the AV receiver.
60
7–3. Tuner
FM/AM Frequency Step 200kHz/10kHz
SAT Radio Mode None
7–3. Tuner
AM Frequency Step 9kHz
Select if 200 kHz/10 kHz steps are
used in your area.
Select if 50 kHz/9 kHz steps are
used in your area.
used in your area.
in your area.
GAME
VCR/DVR
1 Press the [TV/TAPE], [GAME] or
[VCR/DVR] input selector button
so that "TV/TAPE", "GAME" or
"VCR/DVR" appears on the dis-
play.
or
or
2
Press and hold down the [TV/
TAPE], [GAME] or [VCR/DVR]
input selector button (about 3
seconds) to change the setting.
Repeat this step to select MD, CDR, or
DOCK.
or
For the TV/TAPE input selector, the
setting changes in this order:
TV/TAPE
DOCK
For the GAME input selector, the
or
setting changes in this order:
↔
GAME
For the VCR/DVR input selector, the
setting changes in this order:
VCR/DVR
(3 seconds)
Notes:
• DOCK can be selected for the TV/TAPE or GAME or
VCR/DVR input selector, but not at the same time.
• Enter the appropriate remote control code before
using the AV receiver's remote controller for the first
time (see page 141).
TV/TAPE
→ →
MD CDR
→
DOCK
↔
DOCK