Onkyo TX-NR5007 Instruction Manual page 140

Controlling Other Components—Continued
5
Use the Up and Down [q]/[w] but-
tons to select category, and then
press [ENTER].
The brand name input panel appears.
6
Use the arrow [q]/[w]/[e]/[r] but-
tons to select a character, and
then press [ENTER].
Repeat this step from the 1st character
to the 3rd character of the brand name.
When you have entered the 3rd charac-
ter, select "Search" and press
[ENTER].
After searching, a list of the brand
name appears.
If the brand name is not found:
Use the Right [r] button to select
"Not Listed", and then press
[ENTER].
The brand name input panel appears.
7
Use the Up and Down [q]/[w] but-
tons to select brand, and then
press [ENTER].
After searching is completed, a mes-
sage for remote control code transfer
will appear.
140
8–1. Remote Mode Setup TV
Category TV
Brand
A B C D E F G H I J K L
N O P Q R S T U V W X Y
1 2 3 4 5 6 7 8 9 0 – &
Space Back Space
Search
8–1. Remote Mode Setup
TV
Category TV
Brand SON
Sonawa
Sonber
Songba
Sonic
Soniko
Not Listed
8–1. Remote Mode Setup
TV
Category
Brand XXXXX
Now we are ready to transfer data to Remote
Please hold remote so that it is facing the receiver.
Use ENTER button of your remote to activate "OK".
Ready?
OK
M
Z
@
8
TV
9
To use the remote controller, point it at
the AV receiver's remote control sen-
sor, as shown below.
Transmitter
AV receiver
Incoming sensor
15
15
15° off center
(Left/Right/Up/Down)
On the remote controller press the
[ENTER] button.
8–1. Remote Mode Setup
Category
Brand
Wait
When the transfer is successful, the fol-
lowing screen appears. Try it.
8–1. Remote Mode Setup
Category
Brand
1. Push remote Mode [TV].
2. Push some key to see if the TV responds.
3. Push remote Mode [RECEIVER].
4. Choose "Works" or "Doesn't work".
Works
Doesn't work (try next Code)
* When category other than TV have been
selected, the content is different.
If you can control component,
press the [RECEIVER] button,
use the Up and Down [q]/[w] but-
tons to select "Works", and then
press [ENTER].
The "Remote Mode Setup" menu
appears.
If you cannot control component,
use the Up and Down [q]/[w] but-
tons to select "Doesn't work (try
next Code)" and press [ENTER].
The next code is appear.
When you've finished, press the
[SETUP] button.
The setup menu closes.
Approx.
16ft. (5 m)
TV
TV
XXXXX
TV
TV
XXXXX