Adjusting The Anti-Scalp Rollers; Positioning The Seat; Changing The Seat Suspension; Adjusting The Motion Control Levers - Toro 74882 Operator's Manual

Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is recommended
to adjust the height of the anti-scalp rollers.
1. Disengage the blade control switch (PTO), move the
motion control levers to the neutral lock position and
set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Remove the flange nut, anti-scalp roller and bolt from
the bracket (Figure 23).
1
2 3
1. Flange Nut
2. Spacer
3. Anti-scalp roller
4. Align the bolt and anti-scalp roller in the hole of the
bracket that matches the closest height of cut position
(Figure 23).
5. Insert the bolt into the bracket hole and secure the bolt
and anti-scalp roller with the flange nut (Figure 23).
g024312
4
Figure 23
4. Bushing
5. Bolt

Positioning the Seat

The seat can move forward and backward. Position the seat
where you have the best control of the machine and are most
comfortable.
To adjust, move the lever sideways to unlock seat (Figure 24).
5

Changing the Seat Suspension

The seat is adjustable to provide a smooth and comfortable
ride. Position the seat where you are most comfortable.
To adjust it, turn the knob in front either direction to provide
the best comfort (Figure 32).
1. Seat suspension knob
Adjusting the Motion Control
Levers
Adjusting the Height
The motion control levers can be adjusted higher or lower for
maximum operator comfort.
1. Remove the 2 bolts and 2 washers holding the control
lever to the control arm shaft (Figure 26).
2. Move the control lever to the next set of holes. Secure
the lever with the 2 bolts and 2 washers (Figure 26).
22
Figure 24
1
Figure 25
g024881