Drive System Maintenance; Checking The Tire Pressure - Toro 74882 Operator's Manual

1. To replace the main fuse, grasp the fuse and pull it
straight and away from the fuse block.
Figure 43
1. Fuse block
Important: Ensure that the new fuses are the
same type and amperage as the fuses removed.
2. To replace the engine fuse, remove the console from
the plastic fender.
Figure 44
1. Engine fuse
3. Grasp the engine fuse and pull it straight and away
from the fuse block (Figure 44).
4. Align a new fuse with the slot in the fuse block (Figure
43).
5. Push the fuse into the fuse block until the fuse is seated
(Figure 43).
2
1
g02441 1
2. 30 amp main fuse
Drive System
Maintenance

Checking the Tire Pressure

Service Interval: Every 25 hours—Check tire pressure.
Maintain the air pressure in the front and rear tires as
specified. Uneven tire pressure can cause uneven cut. Check
the pressure at the valve stem (Figure 45). Check the tires
when they are cold to get the most accurate pressure reading.
Refer to the maximum pressure suggested by the tire
manufacturer on the sidewall of the caster wheel tires.
Inflate the rear drive wheel tires to 89.6 kPa (13 psi).
1. Valve stem
35
Figure 45