Installing The Mower Deck - Toro 74882 Operator's Manual

Removing the Mower Deck
1. Remove the hair pin cotter and washer securing the
long, link pin to the frame and deck; remove the link
bar (Figure 65).
Figure 65
1. Link pin
2. Washer
2. Lift up on the mower deck to relieve tension from the
mower deck.
3. Remove the chains from the hooks on the deck lift
arms (Figure 66).
Figure 66
1. Deck lift arm
2. Chain
4. Raise the height-of-cut to the transport position.
5. Remove the belt from clutch on the engine.
6. Slide the mower out from underneath the machine.
Note: Retain all parts for future installation.
3. Hair pin cotter
3. Hook
4. Adjustment bolt

Installing the Mower Deck

1. Park the machine on a level surface and disengage the
blade control switch.
2. Move the motion control levers outward to the neutral
lock position, stop the engine, remove the key, set the
parking brake and wait for all moving parts to stop
before leaving the operating position.
3. Slide the mower under the machine.
4. Lower the height-of-cut lever to the lowest position.
5. Place the height-of-cut pin in the lock position for
lowest height-of-cut.
6. Lift the rear of the mower deck and attach the chains
to the rear lift arms (Figure 66).
7. Attach the front chains to the front lift arms (Figure
66).
8. Install the long, link bar through the frame hanger and
deck.
9. Secure the link bar with the hair pin cotters and washers
removed previously (Figure 65).
10. Install the mower belt onto the engine pulley; refer to
Installing the Mower Belt (page 43).
44