Pushing The Machine By Hand - Toro 74882 Operator's Manual

1
G015764
Figure 26
1. Control arm shaft
2. Control lever
3. Slotted, upper hole
3. Repeat the adjustment for the opposite control lever.
2
3
4
5
4. Washer
5. Bolt
Adjusting the Tilt
The motion control levers can be tilted forward or backward
for maximum operator comfort.
1. Loosen the upper bolt holding the control lever to the
control arm shaft.
2. Loosen the lower bolt just enough to pivot the control
lever forward or backward.
3. Tighten both bolts to secure the control in the new
position.
4. Repeat the adjustment for the opposite control lever.

Pushing the Machine by Hand

Important: Always push the machine by hand. Machine
damage can occur when the machine is towed.
To Push the Machine
1. Park the machine on a level surface and disengage the
blade control switch.
2. Engage the parking brake.
3. Move the motion control levers outward to neutral lock
position, stop the engine, remove the key, and wait for
all moving parts to stop before leaving the operating
position.
4. Locate the bypass levers at the rear of the machine, on
the left and right side of the frame.
5. Move the bypass levers rearward and then down to
lock them in place as shown in Figure 27 to disengage
the wheel motors.
Note: Ensure that the left and right bypass levers are
rearward and locked before moving the machine.
6. Disengage the parking brake.
The machine is now able to be pushed by hand.
23