Controls - Toro 74882 Operator's Manual

Controls

Become familiar with all the controls before you start the
engine and operate the machine (Figure 5).
5
4
1. Throttle control
2. Choke
3. Hour meter
Ignition Switch
The ignition switch has three positions: Start, Run and Off.
The key will turn to Start and move back to Run upon release.
Turning the key to the Off position will stop the engine;
however, always remove the key when leaving the machine to
prevent the engine from accidentally starting (Figure 5).
Throttle Control
The throttle control is variable between Fast and Slow.
Moving throttle lever forward will increase engine speed and
moving throttle lever to the rear will decrease engine speed.
Moving the throttle forward into the detent is full throttle
(Figure 5).
Choke
Use the choke to start a cold engine. Pull the choke knob up
to engage it. Push down on the choke knob to disengage it.
Blade Control Switch (Power Take-Off)
The blade control switch, represented by a power take-off
(PTO) symbol, engages and disengages power to the mower
blades (Figure 5).
Hour Meter
The hour meter records the number of hours the blades have
operated. It operates when the blade control switch (PTO) is
engaged. Use these times for scheduling regular maintenance
(Figure 5).
1
2
3
g017722
Figure 5
4. Ignition switch
5. Blade control switch (PTO)
Fuel Gauge
The fuel window located below the operator position can be
used to verify the level of gasoline in the tank (Figure 7).
Motion Control Levers
The motion control levers are speed sensitive controls of
independent wheel motors. Moving a lever forward or
backward turns the wheel on the same side forward or in
reverse; wheel speed is proportional to the amount the lever
is moved. Move the control levers outward from the center
to the neutral lock position and before exiting the machine
(Figure 4). Always position the motion control levers into the
neutral lock position when you stop the machine or leave
it unattended.
Parking Brake Lever
The parking brake lever is located on left side of the console
(Figure 4). The brake lever engages a parking brake on the
drive wheels. Pull the lever up and rearward to engage the
brake. Push the lever forward and down to disengage the
brake.
Foot Pedal Deck Lift System
The foot pedal deck lift system allows the operator to lower
and raise the deck from the seated position. The operator can
use the foot pedal to lift the deck briefly to avoid obstacles
or lock the deck in the highest height-of-cut or transport
position (Figure 4).
Height-of-Cut Lever
The height-of-cut lever works with the foot pedal to lock the
deck in a specific cutting height. Only adjust the height of cut
while machine is not moving (Figure 4).
Attachments/Accessories
A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
13