Servicing The Fuses - Toro 74882 Operator's Manual

1. Disengage the blade control switch (PTO), move the
motion control levers to the neutral lock position and
set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Remove the wing nut securing the battery clamp
(Figure 41).
1
3
Figure 41
1. Remove the wing nut and
clamp
2. Remove the negative
battery cable (black)
before the positive
4. Remove the clamp (Figure 41).
5. First disconnect the negative battery cable (black) from
the negative (-)(black) battery terminal (Figure 41).
6. Slide the red terminal boot off the positive (red) battery
terminal and remove the positive (+)(red) battery cable
(Figure 41).
7. Remove the battery.
Installing the Battery
1. Position battery in the tray with the terminal posts
opposite from the fuel tank (Figure 41).
2. Install the positive (red) battery cable to positive (+)
battery terminal.
3. Install the negative (black) battery cable to the negative
(-) battery terminal.
4. Secure the cables with 2 bolts, 2 washers, and 2 locknuts
(Figure 41).
5. Slide the red terminal boot onto the positive (red)
battery post.
6. Install the clamp and secure it with the wing nut (Figure
41).
2
4
G010240
3. Remove the positive
battery cable (red)
4. Remove battery
Charging the Battery
WARNING
Charging the battery produces gasses that can
explode.
Never smoke near the battery, and keep sparks and
flames away from battery.
Important: Always keep the battery fully charged. This
is especially important to prevent battery damage when
the temperature is below 0°C (32°F).
1. Charge the battery for 10 to 15 minutes at 25 to 30
amps or 30 minutes at 10 amps.
2. When the battery is fully charged, unplug the charger
from the electrical outlet, then disconnect the charger
leads from the battery posts (Figure 42).
3. Install the battery in the machine and connect the
battery cables, refer to Installing the Battery.
Note: Do not run the machine with the battery
disconnected; electrical damage may occur.
1. Positive battery post
2. Negative battery post

Servicing the Fuses

The electrical system is protected by fuses. It requires
no maintenance; however if a fuse blows, check the
component/circuit for a malfunction or short.
Note: The fuses are located on right hand console next to
the seat (Figure 43).
Fuses:
•
Main, 30 amp, blade-type
•
Engine, 20 amp, blade-type
34
Figure 42
3. Red (+) charger lead
4. Black (-) charger lead