Lubrication; Greasing The Bearings; Engine Maintenance; Servicing The Air Cleaner - Toro 74882 Operator's Manual

Lubrication

Greasing the Bearings

Service Interval: Every 25 hours—Grease all lubrication
points.
Grease Type: No. 2 General Purpose Lithium Base Grease
1. Park the machine on a level surface and disengage the
blade control switch.
2. Move the motion control levers outward to the neutral
position, set the parking brake, stop the engine, remove
the key, and wait for all moving parts to stop before
leaving the operating position.
3. Clean the grease fittings (Figure 28 and Figure 29) with
a rag. Make sure to scrape any paint off of the front
of the fitting(s).
Figure 29
1. Front caster tire
4. Connect a grease gun to each fitting (Figure 29 and
Figure 28). Pump grease into the fittings until grease
begins to ooze out of the bearings.
5. Wipe up any excess grease.
1
G009949

Engine Maintenance

WARNING
Contact with hot surfaces may cause personal
injury.
Keep hands, feet, face, clothing and other body
parts away the muffler and other hot surfaces.

Servicing the Air Cleaner

Note: Service the air cleaner more frequently (every few
hours) if operating conditions are extremely dusty or sandy.
Removing the Element
1. Park the machine on a level surface and disengage the
blade control (PTO).
2. Move the motion control levers outward to the neutral
position, set the parking brake, stop the engine, remove
the key, and wait for all moving parts to stop before
leaving the operating position.
3. Clean around the air cleaner cover to prevent dirt from
getting into the engine and causing damage.
4. Lift the cover and remove the hose clamp securing the
air cleaner assembly to the engine (Figure 30).
5. Loosen the hose clamp and remove the paper element
(Figure 30).
3
G015155
1. Cover
2. Paper element
28
2
1
Figure 30
3. Hose clamp