Stopping The Machine; Adjusting The Height-Of-Cut - Toro 74882 Operator's Manual

Driving Backward
1. Move the levers to the center, unlocked position.
2. To go backward, slowly pull the motion control levers
rearward (Figure 20).
Figure 19
G008953
Figure 20

Stopping the Machine

To stop the machine, move the traction control levers to
neutral and move to locked position, disengage the blade
control switch (PTO), and turn the ignition key to off.
Set the parking brake when you leave the machine; refer to
Operating the Parking Brake (page 16). Remember to remove
the key from the ignition switch (Figure 15).
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while it is
unattended.
Always remove the ignition key and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.

Adjusting the Height-of-Cut

G008952
The machine is equipped with a foot pedal deck lift system.
The operator can use the foot pedal to lift the deck briefly to
avoid obstacles or lock the deck in the highest height-of-cut
or transport position. The operator can use the height of
cut lever with the foot pedal to lock the deck in a specific
cutting height.
Using the Foot Pedal Deck Lift System
•
Press the pedal down to raise the deck; continue to press
the pedal until the deck is locked in the transport position
(Figure 21).
•
Push on the deck lift pedal with your foot and pull the
transport lock handle rearward to disengage the transport
lock (Figure 21).
20