Table of Contents
Advertisement
OPTIONAL LOG SET INSTALLATION
Read the instructions below carefully and refer to the images. If the logs are broken do not use the unit until they are replaced. Broken
logs can interfere with pilot operation.
Improper positioning of the logs and lava embers may create carbon build-up and can alter the unit's performance which is not covered
under warranty.
*Satin paint is included if touch ups are required.
1
Rear Log
2
Left Log
3
Right Log
4
Front Right Log Piece
5
Front Left Log Piece - HZ33CE Only
Lava Embers/Rocks
Log Clip - HZ33CE only
Log Brackets - HZ33CE / HZ30E
1
2
5
1. S hut off gas and electrical supply, allow unit to cool to room temperature.
2. Remove fl ush glass door (see unit manual).
3. Carefully remove the logs from the packaging and unwrap them.
The logs are fragile, handle with care -never force into position.
4. Ensure glass crystals are installed on the burner.
HZ33CE = 4lbs
HZ30E=1lb
HZ33CE INSTALL INSTRUCTIONS:
5. HZ33CE only- Install log bracket onto left side of burner with 1 screw
as shown below.
HZ33CE - install
bracket, left side
919-265
HZ33CE/HZ30E - LOG INSTALLATION
3
4
6. Install log clip to lip on burner tray - position 9-1/2" from the left edge
of the burner tray to the centre of clip.
HZ33CE Log Bracket
7. Install Rear Log (1), seat on log clip and rest on left log bracket.
Right side of log should sit fl ush with the outside edge of the pilot hood.
Log 1 in position
8. Place Log 5 on the glass crystals on the left side.
5
HZ33CE shown - Logs 1 and 5 in position.
9. Place Log 4 on the glass on the right side in location shown below.
5
HZ33CE shown - Logs 1,4 and 5 in position.
1
HZ33CE/HZ30E
installation
9-1/2"
HZ33CE Log Clip
1
Log 1 end of Log fl ush
with edge of pilot hood
1
4
Horizon
®
HZ33CE-10 Gas Fireplace
|
41
07/10/13
|
41
Advertisement
Table of Contents
