Table of Contents
Advertisement
installation
|
32
CONVERSION KIT# 438-971 FROM NG TO LP
Each Kit contains one LPG
Conversion Kit # 438-971
LPG Conversion Kit Contains:
Qty. Part #
1
904-241
1
918-590
1
908-528
1
904-529
1
910-101
1
911-011
1
919-433
Installation of the LPG
Conversion Kit:
1.
Shut off the gas supply
2. a) Remove the mesh barrier and glass
door.
b) Remove the Glass Crystals or
Ceramic Stones. Also remove
Inner Panels - if installed.
c) Remove the six (6) screws in locations
shown below to remove burner tray.
3.
Remove 2 screws in location shown in
below - slide burner to the right then lift
out. (See Diagram 2)
919-433
32 |
®
Horizon
HZ33CE-10 Gas Fireplace
For HZ33CE using SIT 885 NOVA Gas Valve
for HZ33CE using SIT 885 NOVA Gas Valve
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER
IF IN DOUBT DO NOT DO THIS CONVERSION !!
Description
Burner Orifi ce #56
Decal "Converted to
LPG"
Red "LPG" label
5/32" Allen Key
LPG Injector
(Pilot Orifi ce)
Stepper Motor
Instruction Sheet
Diagram 1
Diagram 2
Conversion from NG to LPG
4. Remove the wire clip below the pilot cap.
Pilot retainer clip
Diagram 3
Diagram 4
5. Pull off the pilot cap to expose the pilot
orifi ce.
Diagram 5
6.
Unscrew the pilot orifi ce with the Allen
key and replace with the LPG pilot
orifi ce in the kit and replace pilot cap.
Diagram 6
1
HZ33CE
7.
Remove burner orifi ce with a 1/2"
wrench and discard. Use another
wrench to hold on to the elbow below
the orifi ce.
Diagram 7
Burner Orifi ce
8.
Install the new burner orifi ce stamped
#56.
9.
Remove regulator and discard. Install Hi/
Lo pressure regulator onto the valve with
2 screws as shown below.
Diagram 8
10. Attach the label "This unit has been
converted to LPG" near or on top of the
serial # decal
11. Replace yellow "NG" label with red
"LPG" label
12. Reverse steps 2 - 1.
13. Check for gas leaks.
14. Check inlet and outlet pressures.
15. Check operation of fl ame control.
Installer Notice:
These instructions must be left
with the appliance
06.09.14
Advertisement
Table of Contents
