Regency HZ33CE-NG10 Owners & Installation Manual page 35

HZ33CE
Follow these instructions for Existing Installations.
120 Volt AC power is needed for the fan. The fan can be hard wired if
desired. The outlet should be installed in the receptacle box on the left
hand side by a qualifi ed electrician. The neutral (wider) slot of the polar-
ized outlet should be at the top.
Unit must be grounded at all times. Do not cut the ground terminal off
under any circumstances.
1. Shut off the power and disconnect the gas supply.
2. Remove Flush Door, mesh screen, glass crystals, ceramic stones or
beads. Remove the inner panels (if installed).
3. Remove the base tray by removing the 6 screws in the locations
shown below then lift out the base tray. (See Diagram 1)
Diagram 1: Remove the 6 screws and then lift out the base tray.
4. Remove 2 screws in the locations shown below. Slide burner to the
right then lift out (See Diagram 2).
5. Remove the 12 screws securing the valve tray assembly in place.
Then lift the assembly out. (See Diagram 3)
919-423
6. Manoeuvre the fan into the valve tray opening at the base of the
fi rebox
7. Secure the fan by pushing it down onto the mounting pins locat-
ed on the fl oor of the unit. Take care not to damage the insulation
on the fan base. Ensure the fan blades do not rub against the
valve tubing.
8. Connect fan ground wire to to the ground lug. Refer to wiring
diagram
9. Slide the thermodisc/cover assembly on to the bracket clip on
the underside of the fi rebox.
10. Plug in the fan power cord to the Fan Control Module into the
outlet marked "Fan". Plug the FCM-COM wire from the remote
control wiring harness into the location on the Fan Control
Module marked "COM". Turn the switch on theFan Control
Module to the On position. On is to the left. The "O" is the off
position
2
installation
08/14/14
Horizon ® HZ33CE-10 Gas Fireplace
|
35
| 35