Adding Rear Weight - Toro 04520 Operator's Manual

down so that the bar fits over the bar across the top
of the cutting unit (Figure 12).
1
1. Latch—closed position
2. Suspension-arm bar
1
2
1. Suspension-arm bar
6. Close the latches down and around the cutting-unit
bar and lock them in place (Figure 11).
Note: A "click" can be heard and felt when the
latches are properly locked in place.
7. Coat the spline shaft of the cutting unit motor with
clean grease (Figure 13).
8. Insert the motor into the left side of the cutting unit
(as viewed from the operator's position) and pull the
motor retaining bar on the cutting unit toward the
motor until you hear an audible "click" from both
sides of the motor (Figure 13).
2
Figure 11
3. Latch—open position
Figure 12
2. Cutting-unit bar
3
g014609
1. Reel motor
2. Spline shaft
g01461 1
9. Mount a grass basket onto the basket hooks on the
suspension arm.
10. Repeat this procedure for the other cutting units.
8

Adding Rear Weight

Parts needed for this procedure:
Weight kit, 121–6665 (purchase separately) Note: not
1
required for units with the 3 wheel drive kit installed.
Procedure
This unit complies with the ANSI B71.4-2004 and EN
836 Standards when equipped with weight kit 119-7129.
18
2 3
1
Figure 13
3. Cavity
4. Motor retaining bar
4
g014690