Storage - Toro 04520 Operator's Manual

Storage

If you wish to store the machine for a long period of
time, the following steps should be performed prior to
storage:
1. Remove accumulations of dirt and old grass clippings.
Sharpen the reels and bedknives, if necessary; refer
to the Cutting Unit Operator's Manual. Use a rust
preventive on bedknives and reel blades. Grease and
oil all lubrication points; refer to Lubrication.
2. Block up the wheels to remove any weight on the
tires.
3. Drain and replace the hydraulic fluid and
filter and inspect the hydraulic lines and
fittings. Replace, if necessary; refer to
Changing the Hydraulic Oil and Filter (page 44) and
Checking the Hydraulic Lines and Hoses (page 44).
4. All fuel should be removed from the fuel tank. Run
the engine until it stops from lack of fuel. Replace
the fuel filter; refer to Servicing the Filter (page 38).
5. While the engine is still warm, drain the oil from
the crankcase. Refill it with fresh oil; refer to
Changing the Engine Oil and Filter (page 37).
6. Clean dirt and chaff from the cylinder, cylinder head
fins, and blower housing.
7. Remove the battery and charge it fully. Either store
it on the shelf or on the machine. Leave the cables
disconnected if it is stored on the machine. Store
the battery in a cool atmosphere to avoid quick
deterioration of the charge in the battery.
8. If possible, store the machine in a warm, dry location.
47