Installing The Cutting Units - Toro 04520 Operator's Manual

1. Flange bolt
2. Grass basket hook
7

Installing the Cutting Units

Parts needed for this procedure:
1
Gauge bar
3 Cutting unit (model 04613, 04614, or 04615)
3 Grass Basket
Procedure
Note: When sharpening, setting the height-of-cut,
or performing other maintenance procedures on the
cutting units, store the cutting unit reel motors in the
storage location on the front of the suspension arms to
prevent damage to them.
Important: Do not raise the suspension to the
transport position when the reel motors are in the
holders in the machine frame. Damage to the
motors or hoses could result.
Important: Whenever the cutting unit has to be
tipped to expose bedknife/reel, prop up rear of
cutting unit to make sure nuts on back end of
bedbar adjusting screws are not resting on work
surface (Figure 9).
Figure 8
3. Suspension arm bar
g014596
1. Prop (not provided)
Note: All cutting units are shipped with the counter
weight mounted to the right end and the motor mount
and drive coupler mounted to the left end of the cutting
unit.
1. Apply grease to the inside diameter of the drive
coupler.
2. The cutting unit is shipped without a front roller.
Obtain a roller (Model No. 04625, 04626 or 04627)
from your local Toro Distributor. Install the roller
using the loose parts supplied with the cutting unit
and installation instructions included with the roller.
3. If installing the center cutting unit, lift up on the foot
rest and swing it up, allowing access to the center
cutting unit position (Figure 10).
CAUTION
The foot rest can pinch fingers if it falls into the
closed position.
Keep your fingers clear of the area where the
foot rest seats while it is open.
1
1. Footrest—closed
4. Position the cutting unit under the suspension arm.
5. With the latches on the suspension-arm bar pointing
up (i.e., open) (Figure 11), push the suspension arm
17
2
2
Figure 9
2. Bedknife adjusting screw
nut (2)
2
Figure 10
2. Footrest—open
1
g014602