Installing And Removing The Cutting Units - Toro 04520 Operator's Manual

Installing and Removing the
Cutting Units
Installing the Cutting Units
1. Lift up on the foot rest and swing it open, allowing
access to the center cutting unit position (Figure 31).
CAUTION
The foot rest can pinch fingers if it falls into
the closed position.
Keep your fingers clear of the area where the
foot rest seats while it is open.
1
Figure 31
1. Footrest—closed
2. Position the cutting unit under the center suspension
arm.
3. With the latches on the suspension-arm bar pointing
up (i.e., open) (Figure 32), push the suspension arm
down so that the bar fits over the bar across the top
of the cutting unit (Figure 33).
1
Figure 32
1. Latch—closed position
2. Suspension-arm bar
2
2. Footrest—open
2
3. Latch—open position
1
2
1. Suspension-arm bar
4. Close the latches down and around the cutting-unit
bar and lock them in place (Figure 32).
Note: A "click" can be heard and felt when the
latches are properly locked in place.
g014602
5. Coat the spline shaft of the cutting unit motor with
clean grease (Figure 34).
6. Insert the motor into the left side of the cutting unit
(as viewed from the operator's position) and pull
the motor retaining bar on the cutting unit toward
the motor until you hear an audible "click" from
both sides of the motor (Figure 34).
3
g014609
30
Figure 33
2. Cutting-unit bar
g01461 1