Specifications; Attachments/Accessories; Operation; Think Safety First - Toro 04520 Operator's Manual

Specifications

Note: Specifications and design are subject to change
without notice.
Width of cut
Wheel tread
Wheel base
Overall length (w/baskets)
Overall width
Overall height
Net Weight w/reels (11 Blade)

Attachments/Accessories

A selection of Toro approved attachments and
accessories are available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
59.5 inches (151 cm)
50.5 inches (128 cm)
48.6 inches (123 cm)
98.0 inches (249 cm)
70.62 inches (179 cm)
80.83 inches (205 cm)
1535 lb (696 kg)
23

Operation

Note: Determine the left and right sides of the
machine from the normal operating position.

Think Safety First

Please carefully read all of the safety instructions and
symbols in the safety section. Knowing this information
could help you or bystanders avoid injury.
The use of protective equipment, such as but not limited
to, for eyes, ears, feet, and head is recommended.
CAUTION
This machine produces sound levels in excess of
85dBA at the operator's ear and can cause hearing
loss through extended periods of exposure.
Wear hearing protection when operating this
machine.

Checking the Engine Oil

The engine is shipped with oil in the crankcase;
however, the oil level must be checked before and after
the engine is first started.
Crankcase capacity is approximately 3.9 quarts (3.7 l)
with the filter.
Use high-quality engine oil that meets the following
specifications:
• API Classification Level Required: CH–4, CI–4 or
higher.
• Preferred oil: SAE 10W–30
• Alternate oil: SAE 15W–40
Toro Premium Engine oil is available from your
distributor in the 10W–30 viscosity. See the parts
catalog for part numbers.
Note: The best time to check the engine oil is when the
engine is cool before it has been started for the day. If
it has already been run, allow the oil to drain back down
to the sump for at least 10 minutes before checking.
If the oil level is at or below the "add" mark on the
dipstick, add oil to bring the oil level to the "full" mark.
DO NOT OVERFILL. If the oil level is between the
"full" and "add" marks, no oil addition is required.
Important: Be sure to keep the engine oil level
between the upper and lower limits on the oil
gauge. Engine failure may occur as a result of over
filling or under filling the engine oil.
1. Position the machine on a level surface.