1
Installing the Roll Bar
Parts needed for this procedure:
1
Roll bar
4
Bolt (1/2 x 3-3/4 inches)
4
Flange-nut (1/2 inch)
Procedure
1. Remove the top crate support from the crate.
2. Remove the roll bar from the crate.
3. Install the roll bar into the pockets on each side of
the machine, using 4 bolts (1/2 x 3-3/4 inches) and
four flange-nuts (1/2 inch) (Figure 3)
1. Roll bar
2. Bolt (1/2 x 3-3/4 inches)
4. Torque the fasteners to 100 to 110 ft-lb (136 to 149
N-m).
1
2
3
g014601
Figure 3
3. Flange-nut (1/2 inch)
2
Installing the Seat
Parts needed for this procedure:
1
Seat completion kit
Procedure
Acquire your desired seat kit from your distributor and
install it as directed in the instruction included with the
kit.
3
Installing the Steering Wheel
Parts needed for this procedure:
1
Steering wheel
1
Locknut (1-1/2 inches)
1
Washer
1
Steering wheel cap
Procedure
1. Slide the steering wheel onto the steering shaft
(Figure 4).
1. Steering wheel
2. Washer
2. Slide the washer onto the steering shaft (Figure 4).
14
3
2
1
g014687
Figure 4
3. Jam nut
4. Cap
4