Tool Settings - Omron NT-series Operation Manual

Tool Settings

1-13

Tool Settings

Contents of Tool Settings
Auto Refresh
If you start up the Support Tool and select Tool Settings from the Main Menu,
the Tool Settings Display will appear.
Name
NT Model Sets the model of Programmable Terminal being used.
Memory Size Sets the memory capacity of the Programmable Terminal.
Direct Setting Turns ON and OFF the direct connection operation. Refer to
page 17 for details.
Printer Sets the printer model to be used.
Sheet Feeder Sets a sheet feeder for the printer.
Auto Refresh Sets whether or not the screen will be automatically
refreshed when you make screen data additions, deletions,
or modifications.
Display Grid Controls the grid display. If "TouchSW" is specified, each grid
unit will be the size of a touch switch.
Communication Specify the port on the computer to be used to communicate
Port with the PT. If possible, do not specify the same port as the
one used for the mouse.
Temporary Sets the file name for the work file that is temporarily used by
Directory the Support Tool.
Data Directory Sets directory names for saving screen data which is
created.
Press the Enter Key when you want to save the contents of the Tool Settings.
Then either press the Enter Key again to return to the Main Menu, or press
the Escape Key to return to the Tool Settings Display to correct settings.
If you press the Space Key, the tool settings will be changed without being
saved to a file, and you will be returned to the Main Menu.
Press the Escape Key to cancel changing tool settings.
When screen data is added, deleted, or modified with the Support Tool, the
screen display may be temporarily disordered. If Auto Refresh is set to "Yes,"
then the screen display will be automatically rewritten when you return to the
Initial Edit Screen. When creating large amounts of screen data, however,
some time may be required for screen refreshing. Auto Refresh can be set to
Section 1-13
Content
15