Omron NT-series Operation Manual page 90

Stand-alone Operation
Operation
1, 2, 3... 1.
86
PT
PT with Touch Panels (DT___)
PT with Function Keys (DF___)
PT without Function Keys (DN___)
Select EXTEND from the Initial Edit Display to access the Extended Features
Display shown below. This display will appear only if direct connection is set
to No in the Tool Settings.
Use the following procedure to allocate screens to switches/function keys.
Press the Enter Key to access the Stand-alone Setting Display.
Touch switches 231 to 255 cannot be used.
Stand-alone operation is not supported.
12-key Function Key Units
Stand-alone operation is not supported.
32/16 Terminals
F1 to F12 and F17 to F29
10/02 Terminals
Numeral editing not supported. F1 to F10
can be used for stand-alone operation.
Extended Features Display
Section 2-15
Limitations