Receiving Data - Omron NT-series Operation Manual

Receiving Data

Receiving Screens
1, 2, 3... 1.
3. To confirm, press the Enter Key. Press any other key to return to the File
Selection Display.
4. Input the name, using up to 8 characters, of the file in which the trans-
mitted data is to be stored, and then press the Enter Key.
5. Input a title of up to 28 characters, and press the Enter Key.
6. When transmission is complete, a message will be displayed. Press any
key to return to the File Selection Display.
Note If you give the file the same name as an existing file, a message will appear
indicating that the file name already exists, and asking you if you wish to
overwrite the existing file. If it is overwritten, any data stored up to that point
will be cleared. If you wish to overwrite the existing file, press the Enter Key.
If you wish to cancel, return to step 1 by pressing a key other than the Enter
Key and then input another name for the file.
Go to the Screen Selection Display.
2. Press F7 (Receive). The position of the bar cursor is irrelevant.
Section 6-3
111