KTM 690 Enduro R Owner's Manual page 90

SERVICE WORK ON THE CHASSIS
Preliminary work
–
Check the chain tension. (
Main work
–
Loosen nut
–
Loosen nuts
–
Adjust the chain tension by turning adjusting screws
Guideline
Chain tension
Turn the left and right adjusting screws
chain adjusters
rear wheel is then correctly aligned.
Info
The upper chain section must be taut.
Chain wear is not always even. Repeat this measurement at different chain posi-
tions.
–
Tighten nuts
–
Make sure that the chain adjusters
–
Tighten nut
Guideline
100250-10
Nut, rear wheel spindle
p. 86)
.
1
.
2
are in the same position relative to the reference marks
4
.
2
are installed correctly on adjusting screws
4
.
1
on the left and right.
3
5 mm (0.2 in)
so that the markings on the left and right
3
M25x1.5 90 Nm
(66.4 lbf ft)
88
. The
C
.
3