TUNING THE CHASSIS
Info
Before changing the spring preload, make a note of the present setting, e.g., by measuring the length of the spring.
Preliminary work
–
Raise the motorcycle with the work stand.
–
Remove the shock absorber.
–
After removing the shock absorber, clean it thoroughly.
Main work
–
Release retaining ring
–
Turn adjusting ring
Hook wrench (T106S)
–
Measure the overall spring length without a load.
–
Tighten the spring by turning adjusting ring
Guideline
Spring preload
201271-11
Info
Depending on the static sag and/or the riding sag, it may be necessary to
increase or decrease the spring preload.
–
Tighten retaining ring
Subsequent work
–
Install the shock absorber.
–
Mount the side cover.
–
Mount the seat. (
–
Remove the motorcycle from the work stand.
x
.
1
until the spring is fully relaxed.
2
to the specified measurement.
2
20 mm (0.79 in)
.
1
x
p. 82)
72