Installing The Rear Wheel - KTM 690 Enduro R Owner's Manual

WHEELS, TIRES

Installing the rear wheel

12.4
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
Warning
Danger of accidents No braking effect when operating the rear brake.
–
After installing the rear wheel, always operate the foot brake until the pressure point is reached.
x
Preliminary work
–
Raise the motorcycle with the lift stand. (
–
Remove the rear wheel.
–
Check the rear hub rubber dampers.
Main work
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
–
Remove bushing
seal ring
Long-life grease (
–
Clean and grease the thread of the wheel spindle and nut
100269-10
Long-life grease (
–
Install the rubber damper and rear sprocket carrier in the rear wheel.
–
Place the rear wheel in the swingarm and bring the brake disc on the brake caliper into
contact.
x ( p. 118)
Replace the wheel bearing. x
. Clean and grease the working surfaces of the bushing and shaft
1
.
2
p. 198)
p. 198)
p. 76)
x ( p. 120)
.
3
119