Setting Up The Printer; Description; Default Setup - Intermec EasyCoder F4 Installation & Operation Manual

Setting Up the Printer

Description

Default Setup

Intermec EasyCoder F4 – Installation & Operation IPL Version, Ed. 1
The setup controls the printer in regard of serial communication,
test and service operations, and specifi es which types of media and
ribbon are loaded in the printer.
Check the list below to see if the printer's default setup matches your
requirements. If not, you will have to change the setup. To enter the
Setup Mode, press the < Setup> key on the printer's built-in keyboard
and follow the instructions in Chapter 7, "Setup Mode."
The printer is, by default, set up according to the list below:
Communication
Baud rate:
Character length:
Parity:
Stop bits:
Protocol:
Test/Service
Testprint:
Data dump:
Memory reset:
Label rest dots:
Form adj dots X:
Form adj dots Y:
Media
Media type:
Paper type:
Label length:
Media grade:
Media contrast:
Chapter 6
9600 bps
8 bits
None
1 bit
XON/XOFF
n.a.
No
n.a.
0
0
0
Gap
DT
1200 dots
420
0%
35