Toshiba PORTEGE M300 Maintenance Manual page 292

4.28 LCD harness
Installing the LCD harness
To install the LCD harness, follow the steps below and refer to figure 4-44.
1. Arrange the LCD harness along the guide of LCD cover.
NOTE: Arrange the LCD harness to set the marking portion of LCD harness in the
position of gateway of LCD cover.
2. Install the LCD harness holder while locking the hook portion and secure it with the
following screw.
M2.0x3.0S
CAUTION: When installing the LCD harness holder, be careful not to catch the LCD
harness in LCD harness holder.
4-64
S-THIN FLAT BIND screw
4 Replacement Procedures
Be careful not to
catch the harness
Set the marking portion in the position
of the gateway of LCD cover
×1
PORTEGE M300 Maintenance Manual (960-504)