Lcd Mask - Toshiba PORTEGE M300 Maintenance Manual

4.26 LCD mask

4.26 LCD mask

CAUTION: There is no bezel on the LCD. Be careful not to give mechanical stress to
the LCD in the work.
Never scratch the surface of the LCD.
Removing the LCD mask
To remove the LCD mask, follow the steps below and refer to figures 4-41.
1. Remove three mask rubbers and the following screws.
M2.0x4.0S
2. Remove four mask seals and the following screws.
M2.0x4.0S
3. Release the latches on the LCD mask and remove the LCD mask while inserting
your fingers between the LCD mask and LCD unit.
M2.0x4.0S
S-THIN FLAT BIND
4-56
S-THIN FLAT BIND screw
S-THIN FLAT BIND screw
Mask rubber
Mask seal
Figure 4-41 Removing the LCD mask
4 Replacement Procedures
×2
×2
M2.0x4.0S
S-THIN FLAT BIND
Mask seal
M2.0x4.0S
S-THIN FLAT BIND
PORTEGE M300 Maintenance Manual (960-504)