The Clock; Setting The Time Of Day - Rangemaster Professional+ FXP 90 Dual Fuel User's Manual & Installation Instructions

3. The Clock

You can use the timer (Fig. 3.1) to turn the oven(s) on and off.
The clock must be set to the time of day before the oven(s)
will work.
Table 3.1 describes the symbols shown on the digital display.

Setting the Time of Day

When the cooker is first connected to the mains, or if there
has been a prolonged power interruption, the clock display
flashes [ 0.00 ] and [AUTO].
During the time setting process the centre dot will flash.
When the process is complete the dot will stop flashing and
the [] symbol will be displayed.
The time of day can be set in two ways:
• Press and hold the [  ] button. Now press the [+] or [-]
buttons to increase or decrease the time (Fig. 3.2). Holding
the [+] or [-] buttons for more than 2 seconds will advance
/ decrease the set time quickly. Release the buttons to set
the time of day.
• Press and hold both the [] and [] buttons down
(Fig. 3.3). Now press the [+] button (or [–] button) until the
correct time shows.
Do not forget that it is a 24-hour clock.
If you need to reset the clock/cooker, turn off the power and
wait several minutes, then start again.
Automatic Dimming
Providing there are no automatic programs set, and the
minute minder is not active, your clock will automatically dim
during the hours between 22:00 and 06:00.
Minute Minder
Press and hold the [] button (Fig. 3.4), and then press the
[+] button (or [–] button) until the length of time you want to
cook for is shown (Fig. 3.5).
You can check the time remaining by pressing []. When the
beeper sounds cancel it by pressing any button.
•
The 'cook period', which is the length of time you
want the oven to cook for.
•
The 'stop time', which is the time of day you want the
oven to stop cooking.
Setting a Cook Duration
Press and hold the [] button and set the required 'cook
period' by pressing the [+] button (or [–] button) (Fig. 3.6). The
clock will now control the cook period of your oven(s). The
[] symbol and [AUTO] will be displayed.
Once the 'cook period' is reached, the beeper sounds and the
[AUTO] symbol flashes. Turn the oven control knob to 0 and
then press any button to stop the beep. Press [  ] to return to
manual cooking.
ArtNo.302-0002 - 6BC annotated
A B
A – Minute minder, B – 'Cook' time, C – 'Stop' time, D – Manual,
E & F – Time setting buttons
Symbol Function
[]
Minute Minder is active
[]
Oven(s) can be operated
Oven(s) are being
controlled in
[ ]
AUTO
semi-automatic or
automatic mode
Self clean (pyrolytic)
[ ]
P
mode has been enabled
Flashes during setting
[ ]
dot
the time of day
Fig. 3.2
ArtNo.302-0002 - 6BC annotated
Fig. 3.4
ArtNo.302-0002 - 6BC annotated
Fig. 3.6
ArtNo.302-0002 - 6BC annotated
13
C D E F
Notes

[ ]
If the 'cook' symbol is not
displayed the program has either:
• ended and the oven(s) are non-
operational
• the oven(s) are being controlled
by an automatic program that
has not started
Your cooker may not have this
pyrolytic function
Table 3.1
ArtNo.302-0002 - 6BC annotated
ArtNo.302-0002 - 6BC annotated
Fig. 3.1
Fig. 3.3
Fig. 3.5