Repositioning The Cooker Following - Rangemaster Professional+ FXP 90 Dual Fuel User's Manual & Installation Instructions

INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
Fitting the Stability Bracket or Chain
Stability bracket
Fig. 8.5
Unless otherwise stated, a cooker using a flexible gas
connector must be secured with a suitable stability device.
Suitable stability devices are shown in Fig. 8.4, Fig. 8.5 and
Cooker
Fig. 8.6.
If you are using a stability chain (Fig. 8.4) then the chain
should be kept as short as is practicable and fixed firmly to
the rear of the cooker.
3 mm min
If you are using a stability bracket (Fig. 8.5 and Fig. 8.6), then
Floor
ArtNo.070-0014 - Stability bracket - Wall fitting
adjust the bracket to give the smallest practicable clearance
between the bracket and the engagement slot in the rear of
the cooker.
Typical oor mounting
Fit the bracket so that it engages as far as possible over the
Fig. 8.6
Outer stability
chassis of the cooker.
bracket

Repositioning the Cooker Following

Connection
Cooker
If you need to move the cooker once it has been connected
then you need to unplug it and, having gripped under the
fascia panel and lifted the front of the cooker slightly
(Fig. 8.3), you need to check behind the cooker to make sure
3 mm min
that the gas hose is not caught.
Wall
Floor
As you progress, make sure that both the electricity cable and
gas hose always have sufficient slack to allow the cooker to
move.
Typical wall mounting
With a stability chain fitted, release it as you ease the cooker out.
Do not forget to refit it when you replace the cooker.
When you replace the cooker, again check behind to make
sure that the electricity cable and gas hose are not caught or
trapped.
29