Oki ML6300 User Manual page 52

PROBLEM
The platen rotates
without paper feed, or
continuous forms
instead of cut sheets
are fed.
Paper distortion.
Unable to eject.
Improper continuous forms feed.
No line feed, and no
paper feed.
Paper distortion or jam.
Several blank lines
appear in the printout.
CAUSE
Sheets are not loaded
to the end.
The printer is in the
continuous forms mode.
Sheets are not loaded
to the end, or they are
not inserted straight.
Paper with wrinkles,
folds or other defects.
Paper not specified for
the printer.
The FF/LOAD button is
pressed.
Paper is off the Pin
Tractors.
The adjust lever
position does not match
the paper type.
Forms are loaded with
their left holes out of
line with the right ones.
Inadequate distance
between the left and
right Pin Tractors,
making for loose paper.
Skew paper feeding.
Paper movement is
blocked.
Paper source is too far
from the printer.
Paper not specified for
the printer.
Skip over perforation
spacing is selected.
Troubleshooting > 52
ACTION
Load sheets to the end.
Eject the continuous
forms and select cut
sheet mode for the
printer.
Load sheets to the end.
Change paper.
Use paper types
specified for the printer.
Press the PARK button.
Reload paper correctly.
Set the adjust lever to
the correct position.
Load forms with their
left holes in line with
the right ones.
Relocate the Pin
Tractors to tighten the
paper.
Move the paper to make
it straight.
Remove the blockage.
Move the paper source
nearer to the printer.
Use paper types
specified for this
printer.
Cancel the skip over
perforation spacing.