SATO CL4NX Operator's Manual page 205

Configure QR
2 Label Length
3 Pitch
4 Offset
5 Darkness Adjust
Set the length of one piece of the media used
for the test print.
The setting range varies depending on the print
resolution of the printer.
The setting range is as follows:
<CL4NX>
• 203 dpi: 400 to 1600 dots
• 305 dpi: 600 to 2400 dots
• 609 dpi: 1200 to 4800 dots
<CL6NX>
• 203 dpi: 400 to 1600 dots
• 305 dpi: 600 to 2400 dots
Set the print position in the vertical direction.
The setting range varies depending on the print
resolution of the printer.
The setting range is as follows:
<CL4NX>
• 203 dpi: -30 to 0 to 30 dots
• 305 dpi: -45 to 0 to 45 dots
• 609 dpi: -90 to 0 to 90 dots
<CL6NX>
• 203 dpi: -30 to 0 to 30 dots
• 305 dpi: -45 to 0 to 45 dots
When you decrease the setting value, the print
position moves in the feed direction (toward the
front part of the media).
When you increase the setting value, the print
position moves opposite the feed direction
(toward the end part of the media).
Set the stop position of the media.
The setting range varies depending on the print
resolution of the printer.
The setting range is as follows:
<CL4NX>
• 203 dpi: -30 to 0 to 30 dots
• 305 dpi: -45 to 0 to 45 dots
• 609 dpi: -90 to 0 to 90 dots
<CL6NX>
• 203 dpi: -30 to 0 to 30 dots
• 305 dpi: -45 to 0 to 45 dots
When you decrease the setting value, the stop
position moves in the feed direction (toward the
front part of the media).
When you increase the setting value, the stop
position moves opposite the feed direction
(toward the end part of the media).
Fine tune the print darkness of the test print.
0 is the lightest and 99 is the darkest.
4 Operation and Configuration
Note
The value of Label Length,
Pitch, Offset and Darkness
Adjust set in the Configure
QR menu will reflect to the
same item settings in the
Factory menu, Configure
List menu and Paper
Sensor menu.
CL4NX/CL6NX Operator Manual
203