Connecting The Power Cord - SATO CL4NX Operator's Manual

2.5 Connecting the Power Cord

WARNING
• Do not touch the power button, connect or disconnect the power cord while your hands are wet. Doing so
could cause an electric shock.
• Always connect the ground wire to a ground terminal. Electric shock could occur if you do not.
CAUTION
• The attached power cord is designed exclusively for this printer.
• Do not use the attached power cord with other devices.
1
Connect the power cord to the AC input
terminal q at the rear of the printer.
Take note of the orientation of the connector.
Secure the printer with one hand, and insert the
connector tightly.
2
Insert the power plug into an AC outlet.
Make sure that the AC voltage of your region is in
the range of AC 100 - 240 V, 50 - 60 Hz. If your
local voltage is not in the stated range, contact
your SATO reseller or technical support center.
*The shape of the power plug varies depending
on the region in which it was purchased.
Note
This product is also designed for IT power distribution
system with phase-to-phase voltage 230 V.
2 Installing the Printer
1
*
CL4NX/CL6NX Operator Manual
25