Ricoh Caplio 500SE User Manual page 194

Bluetooth
Error Message
REQUESTED FILE CANNOT
PRINT.
REQUESTED FILE CANNOT BE
SENT.
VERIFYING FAILED.
CANNOT CONNECT.
PRINTING FAILED.
CANNOT SEND.
10
192
®
related error messages
Cause and Action
You attempted to send an image other than still ones (.JPG).
Only still images (.JPG) can be sent.
You attempted to send an image other than still ones (.JPG).
Only still images (.JPG) can be sent.
The input pass key did not match the destination device.
Enter the correct pass key.
The passkey was not entered within the time limit. Enter the
passkey again within the time limit.
At the start of transmission, the destination device could not
be connected due to one of the following causes. Check the
device status and start again from the beginning.
• Signal no longer reach the destination device.
• The destination device does not exist nearby (about
10 m).
• The destination device is not active because the power is
off or due to other causes.
• The destination device does not support the Bluetooth
Profiles required for communication with this camera.
• Inappropriate device was selected for the destination.
Printing failed during transmission due to one of the causes
below. Check the device status and start again from the
beginning.
• Signal no longer reach the destination device.
• The destination device is not ready to print.
• There is insufficient space on the destination device.
Transmission was interrupted by one of the following
causes. Check the device status and start again from the
beginning.
• Signal no longer reach the destination device.
• The destination device can no longer receive waves.
• There is insufficient space on the destination device.
Refer to
P.154
P.154
-
P.162
P.154
®
-
-