Jenn-Air FCE70610 Use And Care Manual page 40

To removepullforwardto the "stop"position; _
lift up on the frontof the rackand pull out.
.j o
Before replacingbulb, disconnect power to oven at the main fuse or circuit breaker
panel. Besurethattheentireovencavityincluding the lightbulbiscoolbeforeattempting
to remove,
TO replace light bulb
1. Carefully unscrewthe glass lightlens.
2. To obtainfirm graspon bulb,wear protectiverubbergloves.
Remove by _ming bulb to the left. Do not touch a hot oven _l
light bulb with a damp cloth as bulb wifl break. Note: If the
bulb does break and you wish to removeit, be certainpower
supply is disconnected and wear protective gloves. You
may contact your authorized Jenn-Air Service Contractor for
service,
3. Replace bulb with a 40 watt oven-rated appliance bulb. A I
bulb with brass base is recommended to prevent fusing of
bulb into socket.
4. Replaco bulb cover and reconnect power to oven. Reset
clock.
Beforereplacing lightbulb,DISCONNECT "roPm_MoF
BACKGUARD FLUORESCENT TUBE
POWER TO RANGE.
To replacefluorescent s urfacelight:Grasp
the top trim of backsplashwith thumbs
underfront edge and gently pulloutward
whileliftingtorelease trim from catches at
each end.
Remove bulb and replace with an 18 watt fluorescent tube. Snap top trim back into
place, restore power and reset clock.
40