Output Submenu - Extron electronics in1606 User Manual

Film Mode — Press the Navigation buttons to turn Film Mode 3:2 and 2:2 detection on
(auto detect mode) or off.
Start — Press the Navigation buttons to adjust the horizontal (H) and vertical (V) pixel start
value (analog inputs only).
Active — Press the Navigation buttons to adjust horizontal (H) and vertical (V) active pixels.
Total Pixels and Phase — Press the Navigation buttons to set the number of total pixels
and the phase value (analog inputs only).
HDCP Authorized — Press the Navigation buttons to enable or disable HDCP Authorized.
This setting only applies to digital inputs 3 through 6. When HDCP Authorized is set to
Disabled, the IN1606 outputs a black screen or a warning message generated by the
source if the source attempts to display HDCP-encrypted content.
EDID — Press the Navigation buttons to select an EDID for the active input. Select a
discrete EDID from a list of factory-supplied EDID or select Match Output to use the output
resolution and refresh rate (see Resolution on page 18 for a full list of available resolution
and refresh rates).

Output Submenu

Figure 11. Output Submenu
The Output submenu allows configuration of the output resolution, refresh rate, HDMI
format, and HDCP notification.
IN1606 Scaling Presentation Switcher • Operation 17