Bay Networks 6300 Hardware Installation Manual page 62

Chapter 3 ROM Monitor Commands
3-4 Remote Annex 6300 Hardware Installation Guide
Table 3-1. ROM Monitor Commands (continued)
Command
mop [-d]
(not supported in this
release)
net
option_key [-d]
ping
ports [-d]
sequence [-d | <list>]
stats
Description
Displays and sets
EEPROM values
relevant to VAX/VMS
network addressing,
including the MOP
load/dump address.
Executes an Ethernet
transceiver loopback
test.
Sets or displays the
option key.
Sends ICMP
ECHO_REQUEST
datagram to a host or
gateway.
Shows the current
status of all ports.
Displays and edits the
load/dump interface
list.
Displays current
network statistics
gathered by the ROM.
Use
Loading software
from a DEC VMS
host. This
command is not
used for this
configuration of the
Remote Annex
6300.
Checking your
Ethernet
connection.
Checking your
option key setting.
Checking to see if a
host or gateway
can be reached.
Checking a port.
Checking or
changing the load/
dump interface list.
Checking the
network resources.