Power-Up And Test; Figure C-4. Setting The Remote Annex 6300 To Test Mode - Bay Networks 6300 Hardware Installation Manual

Appendix C Modem Carrier Card Upgrade Instructions

Power-up and Test

C-6 Remote Annex 6300 Hardware Installation Guide
To run the Remote Annex 6300 power-up and test sequence:
1 Reconnect all the cables, including:
The Ethernet cable
The PRI ISDN Interface cable
The console terminal cable
The power cord
2 Turn on the unit's power.
3 Set the Remote Annex 6300 to Test mode by pressing and holding
the button (located on the front panel) for three seconds
Reset
(see Figure C-4).
The Remote Annex runs its ROM-resident power-up diagnostics.
Bay Networks

Figure C-4. Setting the Remote Annex 6300 to Test Mode

Remote Annex 6300
Modem Status
32 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2
Xylogics, a Bay Networks Company
PRI Channel Status
32 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2
Modem Config
Status
13-16 9-12 5-8 1-4
29-32 25-28 21-24 17-20
1
CD
Tx/Rx
Network/Status
Ararms Attn
Test Sync Los Stat Traf
Red Yel Blu Setup Power
1
Reset
Reset
Button