Table 4-6. Errors From Last Erpc Layer Invocation; Table 4-7. Errors From Last Read Request - Bay Networks 6300 Hardware Installation Manual

Chapter 4 Troubleshooting Procedures
4-12 Remote Annex 6300 Hardware Installation Guide

Table 4-6. Errors from Last ERPC Layer Invocation

Error Description
H/W errors The Remote Annex 6300 sensed a hardware error during
message transmission or reception. This error indicates a
fault with the Remote Annex 6300 LAN interface. Use the
net command to isolate the problem (see page 3-23).
Msgs from The Remote Annex 6300 received a message from an
wrong host incorrect host. This indicates that the Remote Annex 6300
received, and ignored, an unsolicited packet.
Rsp T/O's The Remote Annex 6300 never received a correctly
formatted response from the correct host, or any
response from any load server hosts.
Msgs of The correct host sent a message to the Remote Annex
wrong type 6300, but the message was not a correctly formatted
response to the transmitted request.

Table 4-7. Errors from Last Read Request

Error
Msgs with wrong
size
ERPC layer errors
Aborts rx'd
Description
The correct host responded to the Read Request,
but the data size is incorrect.
See Table 4-6.
The host's BFS transmitted an abort in response to
the Remote Annex 6300's Read Request. Run
erpcd –D on the host to obtain more information.