Bay Networks 6300 Hardware Installation Manual page 73

To provide remote access to the Remote Annex 6300 ROMs:
1 From a site local to the Remote Annex 6300:
Put the Remote Annex in test mode so the monitor
prompt appears on the console.
Set the modem to auto-answer mode.
2 From the Remote Annex 6300 console port:
At the monitor prompt, enter console-baud.
At the Select Baud Rate prompt, enter the appropriate
baud rate or auto.
Connect the modem to the R emote Annex's console port.
3 From the remote site:
Dial into the modem connected to the Remote Annex .
Press the
Remote Annex 6300 Hardware Installation Guide
Chapter 3
key until the monitor prompt appears.
Return
ROM Monitor Commands
3-15