Bay Networks 6300 Hardware Installation Manual page 61

Table 3-1. ROM Monitor Commands (continued)
Command Description
boot [-l] [<file>] Erases the existing
Flash memory and
copies a new image to
Flash.
config Displays the current
hardware
configuration and
revision levels.
console-baud Changes the console
port's baud rate.
erase Erases non-volatile
memory.
help Displays the list of
ROM Monitor
commands.
image [-d | <file>] Displays and/or sets
the load image and
tftp load dump names.
ipx [-d] Displays and sets
EEPROM values
(not supported in
relevant to Novell/IPX
this release)
network addressing,
including the IPX
load/dump file server.
lat_key [-d] Sets the LAT key.
(continued on next page)
Remote Annex 6300 Hardware Installation Guide
Chapter 3 ROM Monitor Commands
Use
Upgrading or
replacing the Flash
image.
Identifying your
hardware, memory,
and ROM versions.
Configuring the
console port for remote
maintenance.
Loading a new image
and need to erase the
old image.
Referencing the ROM
monitor commands.
Loading an image that
differs from the
default.
Changing Novell/IPX
configuration
parameters. This
command is not used
for this configuration
of the Remote Annex
6300.
Connecting to a DEC
VMS host.
3-3