Loopback Connectors
10Base2 Ethernet
Loopback
Connector
10Base5 Ethernet
Loopback
Connector
10BaseT Ethernet
Loopback
Connector
Appendix B
T
his appendix describes the loopback connectors.
The 10Base2 loopback connector is a 22-Ohm BNC terminator plug.
This plug places a 22-Ohm resistor between the BNC plug's center
coaxial line and shield.
The 15-pin male Ethernet 10Base5 loopback connector is equipped
with a LED that confirms the presence of the +12-volt transceiver
drive voltage.
Table B-1
Table B-1. 10Base5 Ethernet Loopback Connector
Remote Annex
Pin Number
6300 Signal
3
Transmit +
10
Transmit –
Table B-2
lists the 10BaseT Ethernet loopback connector's pin/signal
allocations.
Table B-2. 10BaseT Ethernet Loopback Connector Wiring
Remote Annex
Pin Number
6300 Signal
1
Transmit +
2
Transmit –
Remote Annex 6300 Hardware Installation Guide
Connectors and Jumpers
shows this connector's pin/signal allocations.
Connects to Pin
Number
5
12
Connects to Pin
Number
3
6
Signal
Receive +
Receive –
Signal
Receive +
Receive –
B-1